Firmware Updates

Use this page when OpenIPC is already installed and the camera boots normally. For first-time installation or recovery, follow the guide for your exact device or SoC instead.

Before updating

• Confirm that the device is running OpenIPC.
• Keep stable power connected during the whole update.
• Note the current firmware target and version.
• Back up any custom configuration that is important for your setup.
• Make sure the camera can reach GitHub if you plan to use the Web UI update button.

Update from the Web UI

1. Open the camera Web UI in your browser.
2. Sign in if the interface asks for credentials.
3. Open Settings -> Firmware or Firmware -> Update.
4. Select Install update from GitHub.
5. Wait for the update process and automatic reboot to finish.

The update can take several minutes. Do not power off the camera while firmware is being written.

Firmware Release Sources

Ready-made OpenIPC firmware images are published in the OpenIPC firmware latest release. Device-specific and customized images for known hardware are published from OpenIPC Builder latest releases. Use the image that matches the exact SoC, flash layout, and board profile for your device.

After updating

• Refresh the Web UI and check the reported firmware version.
• Verify video streaming and any required integrations.
• Reapply custom settings only if they were not preserved.
• If the camera does not boot, use the recovery method documented for your hardware.